Door Progress
Post by barrman on Apr 14, 2006, 4:05pm
During my "Jeep Pilgramage and East Coast Junk Yard Tour" I ended up with a set of really rusted doors. I finally started cutting on them.
Here is the before pic with the markings of where I am going to cut.
Here is the door after the cut.
I will cut the other door tonight if possible and then start making the filler panels.
What do you body work guys think is best.
Make pieces that will fit but don't weld them on until the door is on the truck and in the closed position so it will be "square" all around?
or
Just weld it up and bend/beat it to make it fit later?
Thanks