Quick update. The driveline is largely in place. I still need to shim the various driveline components to make the u-joint angles match. The rear axle pads aren't welded, so I can rotate the pinion as needed.
http://i305.photobucket.com/albums/n...psc7989264.jpg
http://i305.photobucket.com/albums/n...ps3294a0aa.jpg
http://i305.photobucket.com/albums/n...ps6e5d2e1a.jpg
http://i305.photobucket.com/albums/n...ps19758420.jpg
http://i305.photobucket.com/albums/n...ps0f9c601b.jpg
I'm surprised how little effect flex has on the swivel driveshaft. I was expecting a much higher angle.
http://i305.photobucket.com/albums/n...ps46de1390.jpg